An exercise in versatility and customizing options for your Screaming Eagle bagger. This newly designed Dual Touring Saddle provides you and a passenger with sculpted seating and long range comfort. Generously contoured seating platforms provide better weight distribution to eliminate pressure points and give long range support that fits your body. A range of setup options are available for the wide variety of accessories that can be used on this bike model. This is the perfect saddle setup for touring quality comfort on your FLHTCSE. Corbin’s Dual Touring saddle is available for standard FLH and FLT models as well, but this one is designed specifically for the CVO Screaming Eagle model Electra-Glide. Harley-Davidson refers to this model as the FLHTCSE. The largest difference between our standard Dual Tour seat model and this one is that the nose area of the saddle has been redesigned to match up perfectly to fit to the chrome tank panel that comes on the Screaming Eagle model. For other FLH/FLT models.
Corbin’s Dual Touring Saddle also accepts our chrome “V-rail” for an added nostalgic touch, (but not if you are using a Tourpak or Luggage rack). Show quality chrome plating provides a nice touch of class. Our V-rail mounts directly to the Corbin saddle for simple installation that does not require drilling or brackets.
Both the rider and passenger areas accept a removable backrest. Each backrest is fully adjustable for a tailored fit to rider posture. Use a single backrest and transfer it front to rear as needed or you can order two backrests for full time use in your saddle. Corbin backrests lock in with a single screw and can be adjusted without removing them from the seat. In the front we have engineered the backrest to fold down to make it easier to mount the bike. Corbin’s backrest hardware is spring loaded to make the rest pop back upright after you throw your leg over. This special hardware (internal to the saddle) also allows the backrest position fore and aft to be adjusted to your profile. This enables the backrest to be completely customized to fit your riding posture.
For even more versatility, this saddle was also designed to work in conjunction with one of the Tourpaks available from Harley-Davidson. We offer two different trunk pads for this setup depending on how much back support you want for your passenger. The touring pad with arms gives your copilot maximum support and comfort. This works especially well on the larger Tourpak. Our thin trunkpad provides a very clean, low profile look and still gives reasonable support. If you’re using the low profile Tourpak (commonly called the Pizza box) this is a great solution!
If you’re leaning towards a luggage rack rather than the Tourpak, we also happen to make a coordinated pad to fit. Naturally if you use a setup like this, the Chrome V-Rail cannot be installed on the saddle at the same time. If you’re luggage rack is a “detachable” model, you can always transfer your rider’s backrest into the passenger position when the rack is removed from the bike. This allows you to change the look of your bike quickly and easily. Corbin’s luggage rack pad is ergonomically sculpted, just like our backrests to provide excellent support without hot spots. Mounts on your luggage rack like the stock pad.
For the ultimate in luxury, we have built electric seat heaters into our Dual Touring saddle design. A single switch controls the heat for both the rider and passenger positions. The switch is conveniently located along the left side of the saddle so you can reach it without taking your hand off the throttle. The two position switch allows you to select a heat level depending on conditions. The level of heat is controlled automatically by a thermostat built into the control unit. Controller and thermostat come preinstalled on the saddle so installation is a snap.